启动的提示如下：
PCMCIA ATA Flash Card
Compact Flash
Primary IDE Hard Disk
Ethernet
Boot Sequence is reseted due to a PowerUp
Trying to Boot from PCMCIA ATA Flash Card
CD Loader 1.00
Building the boot loader arguments
8172
3629
4411
Relocating the loader and the BTX
Starting the BTX loader
Console: serial port
BIOS drive A: is disk0
BIOS drive C: is disk1
BIOS 639kB/261120kB available memory
FreeBSD/i386 bootstrap loader, Revision 0.8
(
builder@ddraig.juniper.net, Fri Jan 18 07:26:04 UTC 2008)
Hit [Enter] to boot immediately, or space bar for command prompt.
Booting [kernel] in 3 seconds...
Booting [kernel] in 2 seconds...
Booting [kernel] in 1 second...
Booting [kernel]...
Copyright (c) 1996-2008, Juniper
Networks, Inc.
All rights reserved.
Copyright (c) 1992-2004 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
JUNOS 8.4R3.3 #0: 2008-01-18 07:32:48 UTC
[email=builder@ddraig.juniper.net:/volume/build/
junos/8.4/release/8.4R3.3/obj-i386/sys/compile/MFS]builder@ddraig.juniper.net:/volume/build/
junos/8.4/release/8.4R3.3/obj-i386/sys/compile/MFS[/email]
Timecounter "i8254" frequency 1193182 Hz
Timecounter "TSC" frequency 397948788 Hz
CPU: Intel Celeron (397.95-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x68a Stepping = 10
Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
real memory = 268435456 (262144K bytes)
sio0: gdb debugging port
avail memory = 252215296 (246304K bytes)
Preloaded elf kernel "kernel" at 0xc08b8000.
Preloaded md_image "/mdimg" at 0xc08b809c.
DEVFS: ready for devices
Pentium Pro MTRR support enabled
md0: Preloaded image </mdimg> 3940352 bytes at 0xc04f4b68
md1: Malloc disk
Using $PIR table, 14 entries at 0xc00fde60
DRAM Data Integrity Mode: ECC Mode with h/w scrubbing
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Intel 82443BX host to PCI bridge (AGP disabled)> on motherboard
pci0: <PCI bus> on pcib0
isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0xf000-0xf00f at device 7.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
pci0: <Intel 82371AB/EB (PIIX4) USB controller> at 7.2 irq 11
smb0: <Intel 82371AB SMB controller> port 0x5000-0x500f at device 7.3 on pci0
pcic0: <TI PCI-1520 PCI-CardBus Bridge> mem 0xe6045000-0xe6045fff irq 15 at device 13.0 on pci0
pcic0: TI12XX PCI Config Reg: [pci only]
pccard0: <PC Card bus -- legacy version> on pcic0
pcic1: <TI PCI-1520 PCI-CardBus Bridge> mem 0xe6040000-0xe6040fff irq 9 at device 13.1 on pci0
pcic1: TI12XX PCI Config Reg: [pci only]
pccard1: <PC Card bus -- legacy version> on pcic1
fxp0: <Intel Embedded 10/100 Ethernet> port 0xdc00-0xdc3f mem 0xe6020000-0xe603ffff,0xe6044000-0xe6044fff irq 9 at device 16.0 on pci0
fxp1: <Intel Embedded 10/100 Ethernet> port 0xe000-0xe03f mem 0xe6000000-0xe601ffff,0xe6047000-0xe6047fff irq 10 at device 19.0 on pci0
orm0: <Option ROM> at iomem 0xc8000-0xd17ff on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
vga0: <Generic ISA VGA> at port 0x3b0-0x3bb iomem 0xb0000-0xb7fff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: MDA <16 virtual consoles, flags=0x100>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x90 on isa0
sio0: type 16550A, console
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
fxp0: Ethernet address 00:a0:a5:5c:08:1d
DEVFS: ready to run
ata0-slave: ATA identify retries exceeded
Mounting root from cd9660:/dev/md0c
Disabling watchdog
=================== Bootstrap installer starting ===================
Initialized the environment
Routing engine model is RE-5.0
Discovered that flash disk = ad0 , hard disk = ad1
cd9660: /dev/ad3s2: Block device required
mount: /dev/ad1s1f: Block device required
ERROR: mount_partition: Mount /dev/ad1s1a /mnt failed
You are now in a debugging subshell (you may not see a prompt)...
pccard: card inserted, slot 0
#
启动到#下怎样恢复Flash的操作系统。
2001-2007 Comsenz Inc.
